If so, please take our mainboards survey: Click Here! Or, if you'd just like to leave some comments, scroll to the bottom of the page!
Socket 370 Boards
Manufacturer's Website: CLICK HERE! Chipset: VIA MVP3 (100MHz)
Supported CPUs: Intel P54C or P55C (MMX), up to 233MHzAMD K5, K6, K6-2 or K6-3 up to 450MHz (or higher, when CPU is available)Cyrix 6x86L or 6x86MX, MII
BIOS and Driver Updates: CLICK HERE FOR DRIVERS
L2 Cache: 512KB Pipelined Burst SRAM
Expansion Slots: One AGP Slot Four 32-bit PCI slotsTwo 16-bit ISA slotsOne shared
Memory: Memory Capacity: Up to 768MBMemory Sockets: Two 72-pin SIMMs and three 168-pin DIMMsMemory Type: PC/100, EDO, SDRAMData Integrity: ECC/Parity Checking
Onboard I/O: Winbond 83877 with:
One Floppy Controller (2.88MB)
Two Serial Ports (16550 UART compatible)
One Parallel Port (ECP/EPP)
Onboard Graphics: N/A
Onboard Sound: N/A
BIOS: 1Mbit flash ROM (ready for 2M-bit) with:DMI 2.0, Plug and Play
Form Factor: Baby AT
Added Features: Win95 shut-off and Modem ring-on (requires ATX supply)
System Management (SM) Bus
Switching Voltage Regualtor
DIP switch settings
AD22105 CPU temperature sensor
AT & ATX power supply connectors
Below is a list of how you, the users, rate this board: (higher is better!)
So Far 54
of you have given this board an Overall Rating Of:
Ease of Installation Rating: 85.94
You rated the included documentation at: 80.76%
And rated your performance increase at 81.98%
The last few people to rate this board (that also left comments) had this to say:
Deansaid: It is a simple board to install and I find the switches are easier to manipulate than jumpers, with out a doubt a good priced board.
You can find reviews of this mainboard by following the links below!
Click To Go There...
Users experienced in overclocking have left the following comments:
Jonny Vaughan has pushed a CPU with a default speed of 450MHz up to 550MHz! Stability: 8 Remarks: Dunno what temperature is due to crappy AT mobo. It boots windows and seems fine, although I have to have the case open to get enough air flow :)
Q3 runs ok for 20mins.. then dies with a Blue screen of death in 2k.